If you have products inside your clic furniture that get really warm, you can use our ventilation solution.
With a clic ventilation you can divert the heat from the items you have placed inside your clic furniture, usually behind a wood or a fabric door.
The ventilation is mounted under the cable hole in the top of the furniture
When placing a ventilation in a furniture with a wood door or a fabric door you will as a minimum
insure the same ventilation as a furniture with no door
Because the heat will rise, we have made a ventilation solution mounted just under the top plate in the furniture. It will pull the warm air from inside the furniture up through the top.
Cold air will be pulled in through the cable hole in the bottom of the furniture.
When you order a furniture don’t forget to take into consideration how many cable holes you need.
The ventilation will not be audible from more than 2 meters distance.
Power cable included.
The ventilation is controlled by temperature. It will not start just by connecting the power.
It will start up at approximately 30 degrees with 800 rpm. At approximately 40 degrees it goes up to 1200 rpm.
It will slow down and stop when the temperature falls.
When using the ventilation the back plate in the furniture must be removed.
The ventilation size is 13 cm. down and 15 cm in the depth of the furniture.
The ventilation can’t be fitted in the following models:
A furniture fitted with drawers.
Be aware that our ventilation can only be placed in a cable hole that is not placed above a vertical beam in the furniture. It’s important you consider this when ordering your furniture and how many holes you order in the top plate.
A manual will follow your order and can also be found under Support.
Call us at
or write us at